M 3..7
24
EN
On the inner part of the cover you can find the name of the application type (1), as well as the
serial number (2) and the article number (3).
Gerät an Schutzleiter
anschließen!
Appliance must be earthed!
AAAA BBBB
CCCC
1 32
Fig. 8:
“Rating plate cover”
3.1.1 Removing the cover
Under this cover, the rating plate and the hood screw are located.
1. Push the cover at the corrugation towards the wall bracket.
2. At the rear corners press the cover down until the front edge lifts.
3. Remove the cover by pulling forward.
Fig. 9:
“ Removing the cover”
As soon as the hot water tap is opened, the instantaneous water heater switches on automati-
cally. Close the tap and the appliance switches off automatically again.
Use
3. Use
3.1 Rating plate cover
To Next Page
Loading...
