Installing the Main Unit
84
MAX973HD
English
INSTALLATION AND WIRE
CONNECTION MANUAL
Installing the main unit in a TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked ★ are attached to the vehicle.)
Note:
*1: Some panel openings are too small for the unit
depending on the vehicle type and model. In
such a case, trim the upper and lower sides of the
panel frame by about 0.5 to 1.5 mm so the unit
can be inserted smoothly.
*2: If a hook on the installation bracket interferes
with the unit, bend and flatten it with a nipper or
similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the centre panel may require modification. (Trimming, filing, etc.)
Removing the main unit
When the main unit is to be removed, disassemble it in the reverse of the order listed in this section.
Mounting bracket
(1 pair for the left
and right sides)
8–Hexagonal screw
(M5 u 8)
Centre Panel
(* 1)
Main Unit
(* 2)
Affix the screws to the ● marks.
Example 1
Typical Mounting Brackets
Example 2 Example 3
To Next Page
Loading...
Need help?
General
