Clark CER10 - How to Use the Battery and Cautions for Charging

1 – 10
Do not over discharge.
If the equipment is used until it is not
moving, the battery life is shortened.
Charge immediately when the green
lamp in the volumeter is off and the red
lamp flickers.
Read the specific gravity of electrolyte
before charging. According to the
difference of specific gravity after
charging, the abnormality inside of the
battery is found and an accident can be
prevented in advance.
The charging place must be covered from the rain and well ventilated.
Do not let the battery be out of
electrolyte.
When charging, the moisture of
electrolyte (diluted lactic acid) decreases.
Therefore, surely fill up water to the
max. level before charging.
Note
When filling up water in the electrolyte,
use only distilled water or refined water.
Before charging, surely check if there is
any slackened part in the plug or
terminal.
Keep clean.
Specially keep the top surface of battery
clean and dry. Also, close the cover
surely.
!
!
!
!
!
!
8. HOW TO USE THE BATTERY AND CAUTIONS FOR CHARGING