EasyManua.ls Logo

Clark CER10 - Cautions When Operating the Machine

Clark CER10
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 12
a Do not overdischarge.
b Do not lift up or push the load with the fork tip.
c Do not load the fork lift over capacity limit (allowable load).
d Avoid a sudden start, stop, or turn.
e Do not operate the valve suddenly with the mast raised and the luggage loaded.
f Before leaving the machine, remove the start key, make sure that the machine
doesn’t move by pressing the accelerator, and put down the fork on the ground.
g If you do not lift up the folk to the max. height while working, lift up the fork to
the max. height several times before finishing the daily work.
(If you keep working at low height, it may cause the rust in the inside of lift
cylinder.)
h When inspecting the electric system, disconnect tje battery plugs.
i When having a pause or charging, remove the start key.
j Clean the electric systems with compressed air.
k Do not use a charger instead of a battery or other kinds of batteries except the
battery installed. Otherwise it may cause a trouble.
9. CAUTIONS WHEN OPERATING THE MACHINE

Table of Contents

Related product manuals