EasyManua.ls Logo

Clark CER10 - Battery Charging; Normal Charging

Clark CER10
92 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 16
14.1 NORMAL CHARGING
Note
This is all about battery charger designated by CMHA. if you want to use a
different charger, please refer to the operation manual of the charger which is
included the charger.
It depends on the discharging condition or capacity of battery, but generally it
takes 8 or 10 hours continuously to charge. Charger has a stationary automatic
charging system. Push the button in order to start charging. When the charging
is completed, it stops automatically.
When the red lamp flikers while traveling or when you finish daily working,
charge as the directions below.
1 The charging place must be covered from the rain and well ventilated. There
must be no flammable around the charger.
2 Turn the key switch to OFF.
3 Connect a charging plug to a plug in the machine.
4 Insert a power plug into a plug socket.
5 Make sure that the power plug is inserted properly. If the connection is proper,
automatic charging lamo and equal charging lamp light up.
6 If push automatic charging button, automatic charging lamp is constantly ON
and equal charging lamp is OFF. At the same time, charging starts.
!
14. BATTERY DHARGING
Check lamp
Automatic charging button
Equal charging button
Stop button
Charging sequence lamp

Table of Contents

Related product manuals