Clark CER10 - Inspection Every 2 Months (400 Hr); Inspection Every 3 Months (600 Hr); Inspection of Carbon Brush

3 – 8
22.6 INSPECTION EVERY 2 MONTHS (400 HR)
Inspecting the contactor
When inspecting the contact points, if there are damages, repair and replace the
items according to the degree of damage. (For details, refer to “21 GUIDE TO
REPLACE AND REPAIR PARTS”)
22.7 INSPECTON EVERY 3 MONTHS (600 HR)
Inspect the following items addition to the items to be inspected per every month
(200hr) and every 3 months (600hr). If there are items to require adjusting or
replacing, contact to your local dealer.
22.8 INSPECTION OF CARBON BRUSH
Lift up the oil spring and pull out the
carbon brush to inspect. Inspect the
roughness of commutator. If the brush
reaches to the wear limit, the brush wear
lamp on the LCD is lighted up. (option
specification)
22. INSPECTION AND MAINTENANCE
3 months
v
v
6 months
v
v
v
v
v
Items
Contractor
Motor
Drive case
Hydraulic oil
Oil filter
Contents
If the contact point is excessively rough,
replace it
Check the worn part of carbon brush
Replace gear oil
Check the contaminated oil and replace them
Clean oil filter
Coil spring
Carbon brush
Commutator