3 – 1
If the inspecting and maintenance is surely carried out, an accident can be prevented
and the life of machine becomes long. Even if you are busy, fix the date and carry
out the periodic inspection so as to increase the working ratio of machine and to
reduce the maintenance cost of machine. Also, the hour written in the inspection
item is based on 8hours of a day and 200hours of a month. At actual inspecting,
make out the schedule in the unit of day and date, etc. Before starting operation,
check the periodic inspection schedule, and when that inspection time comes to,
check the checking points.
22.1 GENERAL CAUTIONS FOR INSPECTION AND MAINTENANCE
a Use the genuine part of our company to replace a part.
b Use the recommended oil, especially hydraulic oil, must be the recommended
domestic supply oil.
c To supply oil, clean up the grease on the oiling inlet with brush or cloth at
first.
d To supply or drain oil and to check the oil level, stop the machine on an even
ground and carry out.
e To inspect the electric system, disconnect the battery plug and carry out.
22.2 INSPECTION EVERY WEEK (50HR)
1) Inspecting electrolyte
For inspecting the level of electrolyte,
check the condition of battery and float
from outside. If the float lowers down, fill
up the electrolyte immediately. To fill up
the distilled water, open the cover
completely. When the float goes up and
the white line is to be seen, stop filling
up the distilled water.
22. INSPECTION AND MAINTENANCE
Appropriate
level
Appropriate
(Float is seen.)
To Next Page
Loading...
