Clark CER10 - Operating and Unloading; Preparation for Starting; Operating

2 – 31
Check the safety around the machine and sit down on the operator’s seat.
21.1 PREPARATION FOR STARTING
a Hold the steering wheel knob lightly with your left hand and turn the start switch
to ON position.
b Pull the lift lever in order to lift the fork about 20~30cm from the ground, pull
the reach lever backward in order to pull the mast, and pull the tilt lever
backward so that the forks are tilted backward.
21.2 OPERATING
21.2.1 START
Depress the brake pedal and operate the traveling control lever slowly in order
to start. The speed of the machine depends on the control of the lever.
21. OPERATING AND UNLOADING
FX934
ON
Left turn
Stop
Reverse
Forward
Reach out
Reach in
Tilt forward
Lift up
Lower
down
backward
Tilt
Start
Right turn