2 – 32
• You must decelerate in following cases.
• When turning suddenly, or approaching the load and pallet (without load)
• When approaching the place to unload (with load)
• When driving a place where excessively narrow, or uneven road
21.2.2 TURNING
The forklift has rear wheel steering system apart from other general vehicles.
Therefore, slow down in advance before turning. Move the machine to the
turning direction and turn the steering wheel slightly first and then make a turn
as giving special attention to the backside.
21.2.3 STOPPING
Put the travel control lever to the original position, and release the brake pedal
slowly.
21.2.4 PARKING
When leaving the operator’s seat, pull the mast backward, tilt the mast forward
and lower down the fork to the ground. Also, remove the start switch.
21.3 LOADING
When loading, carry out in following orders.
a When the machine approaches near to the loading place, slow down to the
safe speed.
b When the machine arrives at the loading place, stop.
c Check the safety of loading place.
d Tilt the mast to the horizontal position (tilting forward) and lift up slightly higher
than the loading position.
e Surely check the loading position and slowly stop the machine at the proper
position.
f Pull the load to the unloaded place by reach operating.
g After checking that the load is on the loading position, slowly lower down and
make sure that the load is loaded safely.
21. OPERATING AND UNLOADING
To Next Page
Loading...
