2 – 30
a Do not overdischarge
b Do not lift up or pull the load with the tip end of the fork.
c Do not load fork lift over capacity limit( allowable load).
d Avoid a sudden start, stop, or turn, otherwise it may cause dangers.
f Do not operate the valve suddenly when the mast is raised with load.
g Before leaving the machine, remove the start key, make sure that the machine
doesn’t move by pressing an accelerator, and put down the fork to the ground.
h If you do not lift up the folk to the max. height while working, lift up the fork
to the max. height before finishing daily working. (If you keep working at the
low height, it may cause the rust in the inside of lift cylinder.)
i When checking the electric system, disconnect battery plugs.
j When having a pause or charging, remove the start key.
k Clean electric devices with compressed air
l Do not use a charger instead of a battery, or other kinds of batteries except
the battery installed. Otherwise it may cause a trouble.
20. LOAD AND STABILITY OF MACHINE
To Next Page
Loading...
