Clark CER10 - Check Before Working; Checking Points; Checking Methods Before Starting Operation; Load and Stability of Machine

0 – 3
19. CHECK BEFORE WORKING
19.1 CHECKING POINTS
................................................................................................................
2 – 24
19.2 CHECKING METHODS BEFORE STARTING OPERATION
....................
2 – 25
20. LOAE AND STABILITY OF MACHINE
20.1 STANDARD LOAD CENTER AND LOAD CURVE
.........................................
2 – 28
20.2 STABILITY OF MACHINE
...................................................................................................
2 – 29
21. OPERATING AND UNLOADING
21.1 PREPARATION FOR STARTING
..................................................................................
2 – 31
21.2 OPERATING
...................................................................................................................................
2 – 31
21.3 LOADING
..........................................................................................................................................
2 – 32
21.4 UNLOADING
...................................................................................................................................
2 – 33
[ INSPECTION AND MAINTENANCE ]
22. INSPECTION AND MAINTENANCE
22.1 GENERAL CAUTIONS FOR INSPECTION AND MAINTENANCE
.....
3 – 11
22.2 INSPECTION EVERY WEEK (50HR)
........................................................................
3 – 11
22.3 MEASURING SPECIFIC GRAVITY
..............................................................................
3 – 31
22.4 CLEANING BATTERY
............................................................................................................
3 – 41
22.5 INSPECTION EVERY MONTH (200HR)
..................................................................
3 – 51
22.6 INSPECTION EVERY 2 MONTHS (400HR)
........................................................
3 – 81
22.7 INSPECTION EVERY 3 MONTHS (600HR)
........................................................
3 – 81
22.8 INSPECTION OF CARBON BRUSH
..........................................................................
3 – 81
23. LUBRICATION CHART
23.1 LUBRICATING POINT
............................................................................................................
3 – 91
23.2 SPECIFIED LUBRICATION CHART
............................................................................
3 – 10