2 – 26
4 Checking the pipes
Check if there is any leakage from the
cylinders or pipes.
5 Checking the hydraulic oil level
Completely lower down the fork on a
firm and even ground, and tilt the mast
backward, and check the oil level
through the oil level gauge in oil tank.
In case of CER10-CER18, Check if you
see the surface of the oil
In case of CER20-CER25, Check the
oil level with a deep stick.
The proper level of the hydraulic oil is
between “H” and “L” mark.
6 Checking and adjusting the tension of lift
chain
Lift up the fork about 20 or 30cm and
push the chain one by one to check
that the tension of right and left is
equal. Also, check if the pin cover is
inclined to one side or not. If the
tension of chain is not equal, adjust the
chain anchor bolt. After adjusting,
tighten the lock nut firmly.
7 Checking tires
Check if there are damage or abnormal
worn parts for each tire (drive, caster,
load).
8 Checking bolts on the tires
Check if there is loosed bolts on the tires.
9 Checking charging condition
Measure the gravity of battery electrolyte with the gravimeter. If the gravimeter
indicates 1.260~1.280 at 20°C, charging is completed.
19. CHECK BEFORE WORKING
H
L
FX916
[CER10/18]
[CER20/25]
FX917
Level
gauge
Level
gauge
Lift chain
Chain
anchor
To Next Page
Loading...
