Page -16- Clarke
®
Operator's Manual - BOOST 28
How To Operate The Machine
Figure 15
Figure 16
Figure 17
Figure 17A
C
How To Operate The Squeegee
The squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor. Use your
hand to lower or raise the squeegee handle. To
operate the squeegee, follow this procedure:
1. To lower the squeegee and start the vacuum
motor, move the squeegee lever to the right and
down. See figure 15.
2. To raise the squeegee, lift the squeegee lever up.
See figure 16.
NOTE: The center position lets the vacuum motor
continue to run with the squeegee off the floor to avoid
drips and also allows you to back up the machine.
How To Fill The Solution Tank
The solution tank can be filled in the front or through
the clear drain hose at the rear of the machine (See
figure 17). To fill the solution tank follow this proce-
dure:
1. Add a cleaning chemical to the solution tank.
For the correct amount of chemical, follow the
directions shown on the container.
2. Fill the solution tank with water. When filling
machine in the front with a hose, position hose
inside the fill screen as shown in figure 17A.
When filling machine from the rear, position clear
drain hose against bracket and insert hose as
shown in figure 18 Solution level can be viewed
from the back of the machine.
Figure 18
To Next Page
Loading...
Need help?
General
