Page -18- Clarke
®
Operator's Manual - BOOST 28
How To Clean A Floor
WARNING: Water solutions or cleaning materials
used with this type of machine can leave
wet areas on the floor surfaces. These
areas can cause a dangerous condition for
the operator or other persons. Always put
CAUTION signs near the area you are
cleaning.
To clean a floor follow this procedure:
1. Set the parking brake (if equipped with machine.)
2. Put the water and a cleaning chemical in the clean
solution tank.
3. Release the parking brake (if equipped with machine.)
4. Turn the key switch "ON".
5. Lower the squeegee.
6. Put the brush switch in the down position.
7. Turn the solution knob to the right to activate the flow of
solution. Adjust the flow of clean solution to the flow
desired.
8. Move the machine across the floor in the forward
direction.
9. Make a 180° turn.
NOTE: When you make more passes across the floor, let the
brush clean approximately 2 inches (5 cm) of the area already
cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove
the solution in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1. Apply solution to the floor.
2. Do not lower the squeegee. This will keep the vacuum
motor off.
3. Lower the brush or pad and scrub the floor.
4. Scrub the floor again with additional solution and lower
the squeegee.
5. Pick up all the solution with the squeegee.
How To Operate The Machine (cont)
To Next Page
Loading...
Need help?
General
