Clarke Focus II User Manual

ENGLISH
Operator’s Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
17
Solution or washing water tank lling
NOTE
If the machine is equipped with Chemical Mixing System
(optional) the tank must be lled with clean water,
otherwise the tank must be lled with solution.
Open the ller neck (A, Fig.14).1.
(2. For machines without Chemical Mixing System)
Use the front ller neck (B) or the rear ller neck (C) to ll the
tank (D) with a solution suitable for the work to be performed.
Rell to the reference mark “1” of the level check hose (H).
Always follow the dilution instructions on the label of the
chemical product used to prepare the solution.
The solution temperature must not exceed +104°F (+40°C).
WARNING!
Use only low-foam and non-ammable detergents,
intended for automatic scrubber applications.
(3. For machines with Chemical Mixing System)
Fill the tank (D) with clean water by using the ller neck (B)
or the rear ller neck (C).
Rell to the reference mark “1” of the level check hose (H).
The water temperature must not exceed +104°F (+40°C).
Detergent tank lling (For machines with Chemical
Mixing System)
Open the cover (E) and check that the recovery water tank 1.
(F) is empty, otherwise empty it with the drain hose (G).
Carefully lift the tank (A, Fig. 15).2.
Open the cap (B).3.
Replace or ll the jug (C) with any standard gallon container 4.
of detergent suitable for the work to be performed (highly
concentrated detergents).
Do not ll the detergent tank completely, leave a few
centimeters from the edge.
WARNING!
Use only low-foam and non-ammable detergents,
intended for automatic scrubber applications.
NOTE
To install a new jug container, determine the cap size and
if it is the smaller cap, remove the reducing adapter from
the hose cap (B). Insert the suction tube into the jug (C).
Pushdown rmly on the cap (B) and twist at the same
time to put the cap back onto the jug (C).
In case of new system, system emptied for cleaning, etc.,
wait for the hoses to ll up, before starting the Chemical
Mixing System.
Figure 14
Figure 15
B ENGLISH.indd 17 14/04/2010 12.48.24

Clarke Focus II Specifications

General

Cleaning Path	20 inches
Power Source	Battery
Brush Motor	0.75 hp
Battery Voltage	24 V
Voltage	36V
Vacuum Motor	0.5 hp