EasyManua.ls Logo

Clear-Com HME DX210 - Page 11

Clear-Com HME DX210
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Clear-Com HME DX210 Operating Instructions
Insert a battery in each of four charging ports until it clicks in place.
A yellow light next to each charging port stays on while the port is empty.
When a battery is in a charging port, a flashing yellow light next to it indicates CHARGE PENDING,
which means the battery is too hot. Adjust the room temperature or move the charger to a cooler area.
When a battery is in a charging port, a yellow light on steady next to it means CHARGE FAILED.
If this happens, follow the instructions on the side of battery charger.
A red CHARGING light next to a battery port stays on while a battery in the port is charging.
A green READY light next to a battery port goes on when a battery in the port is fully charged.
Store fully charged batteries in storage ports.
NOTE: Batteries should not be left in charge ports after being fully charged. If a battery is left in a
charge port for more than three weeks, the yellow indicator may light up. In this case, it does not indicate
a faulty battery.

Related product manuals