Clear-Com HME DX210 - Register Beltpacks and All-In-One Headsets

9
Clear-Com HME DX210 Operating Instructions
2.3.2 Register Beltpacks and All-in-One Headsets
The beltpack or all-in-one headset must be within 6 feet (1.83 meters) of the base station to enable
registration.
1. Be sure each beltpack and all-in-one headset to be registered is turned off and the base
station power is on before you begin. Beltpacks and all-in-one headsets that are already registered
can be on or off.
2. Put the headset on your head.
3. Press the REG button on the front panel of the base station. The STATUS display will show a small
“o” for open.
4. NOTE: If you wait too long before proceeding to the next step, the base station will exit registration
mode, and you will have to repeat step 3.
5. Press and hold the ISO button on the beltpack or all-in-one headset while pressing and releasing the
PWR (power) button to turn the unit on, then release the ISO button. This will cause the beltpack or
all-in-one headset to enter the registration mode.
If registration is successfully completed:
● A voice message in the headset will say “Power on, Beltpack #, Version #, Begin registration,
Registration complete, …”
● After a delay of about 15 seconds, the STATUS display will show the ID number assigned to this
beltpack or all-in-one headset for about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
● The power light on the beltpack or all-in-one headset will remain on steady green.
If registration failed:
● A voice message in the headset will say “Power on, Beltpack #, Version #, Begin registration, …”
Both lights on the Beltpack will blink red, and there may be a delay of up to 90 seconds before you
hear “Registration failed”.
● Press the RESET button at the lower-left corner of the base station with a pen or similar pointed
object. When the STATUS display becomes blank, press the REG button and register the beltpack or
all-in-one headset again. If registration fails again, call your dealer for assistance.
REG button
STATUS display “o”
On Beltpacks, the two power lights at the corners near the IC1 and IC2 buttons will begin blinking
red, then blink green two or three times and turn off. Wait! There may be a short delay.
On All-In-One Headsets, the power/mode lights will blink. Wait! There may be a short delay.
Repeat Steps 2 to 4 above for each beltpack or all-in-one headset to be registered.