Interference Avoidance through
Spectrum Friendly
Interference, heard in a headset as popping sounds, may occur whenever other equipment such as Wi-
Fi systems or wireless DMX systems use the same frequency band. Some systems can be limited to
one portion of the band. If so, the DX210 can be set to the opposite half of the 2.4 GHz to 2.48 GHz
band. To avoid this type of interference, select the upper or lower part of the frequency range.
● Turn on the base station power. An “8” will appear on the STATUS display for a few seconds.
● After the “8” disappears from the STATUS display (primary base station) or displays a double bar
(secondary base station), press and hold the CLR/BND button. Then, while you are still holding the
CLR/BND button, press and hold the REG button and wait until a L, H or A appears and then release
both buttons.
NOTE: Base stations are shipped in the A (default) position.
● Press the CLR/BND button to cycle through parts of the
frequency band, (L = Low end, H = High end, and A = All)
and stop on the desired setting.
● Wait until “c” appears on the display.
NOTE: “c” will only appear on the STATUS display if you are setting the frequency band the first time, or
you are changing the setting. If you stop at L, H or A that was already set, an “8” will appear for a few
seconds and the STATUS display will become blank.
● Register all beltpacks and all-in-one headsets to be used with each base station as instructed in
section 2.3.2, page 9.
NOTE: If you change a base station’s frequency band setting, you will have to re-register all beltpacks
and all-in-one headsets that were registered to that base station.
To Next Page
Loading...
Need help?
General
