Appendix G: DX Series LED Aid
Powering on any DX base station will produce on the LED display the number “8” for approximately 3
seconds.
Blank display indicates the base is ready for operation.
You can register Beltpacks under this condition.
Single horizontal bar indicates the base is in secondary mode and registering to a base has been initiated
and successfully linked with a primary base. You can register beltpacks in this mode.
Two horizontal bars indicate that the base is in secondary mode and ready to be synced with a primary
base. You cannot register beltpacks in this mode you must sync to a primary base first.
Three horizontal bars indicate the base is in secondary mode and has been linked with a primary base but
the primary base is no longer available to the secondary. It takes a few seconds for the secondary to
recognize that the primary is not available and revert to a primary state. However, you can register
Beltpacks under this condition.
To Next Page
Loading...
