2.3 Beltpack and All-in-One Headset Setup and Registration
The first time you operate the DX210 system, you must register each Beltpack and/or All-In-One
Headset for use with a specific base station. The base station will then recognize all powered on,
registered beltpacks and all-in-one headsets and will differentiate between them and other electronic
equipment operating on the same frequencies. If another is added or replaced later, the new one must
be registered and the old one remains in memory. A maximum of 15 beltpacks and all-in-one headsets
can be registered to a single base station at one time.
2.3.1 Set Up Beltpack and All-in-One Headset
NOTE: If multiple base stations will be used or if interference is present, such as Wi-Fi interference, refer
to Base Station Registration and Interference Avoidance in Appendix D and E on pages 24 through 26.
Before registration, set up all beltpacks and all-in-one headsets as follows:
Beltpacks
1. Insert a fully charged battery in
each Beltpack, with the metal
contacts on the end of the
battery inserted first.
Press it in until it snaps.
2. Place each Beltpack
in a pouch.
3. Plug its headset cable connector
into each Beltpack.
All-In-One Headsets
Insert a fully charged battery in each Headset. Press it in until it snaps.
To Next Page
Loading...
Need help?
General
