Clear-Com HME DX210 User Manual

10
Clear-Com HME DX210 Operating Instructions
If you try to register more than 15 beltpacks and all-in-one headsets:
● An F will appear on the STATUS display on the base station and you will hear “Registration failed” in
the headset.
● Clear all current registrations by pressing the CLR/BND button and the RESET button
simultaneously. To press the RESET button, insert a pen or similar pointed object into the RESET
hole at the lower-left corner of the base station front panel. Continue holding the CLR/BND button after
you release the RESET button, until the clear code “c” (lower case) appears on the STATUS display.
● Register all active beltpacks and all-in-one headsets, one at a time. Previously registered beltpacks and
all-in-one headsets must be re-registered.
2.3.3 Beltpacks and All-in-One Headset Settings
If you want to set up a beltpack or all-in-one headset with any of the special settings shown below, press
and hold the specified button combinations during or after power up. These settings will remain in
memory when the beltpacks and all-in-one headsets are turned off and on again.
For Setting
Press & Hold while you Press & Release the Power button
ISO restrict on
IC1 button
ISO restrict off
IC1 and ISO buttons
Handsfree on selected button(s)
IC1 and/or IC2 and/or ISO and ▲ volume up buttons
Handsfree off selected button(s)
IC1 and/or IC2 and/or ISO and ▼ volume down buttons
Listen-Only mode on
▼ volume down button
Listen-Only mode off
▲ volume up button
WH220 only *
All-In-One Headset “lights-off” mode
IC2 button
* NOTE: All-In-One Headsets can be set up with its indicator lights off, to avoid distraction if users are in an area
visible to audience. This setting is not saved when you power off.
For Setting
With the power already on - - -
Increase mic gain (15 steps)
Press IC2 while you repeatedly press the ▲ volume up button
Decrease mic gain (15 steps)
Press IC2 while you repeatedly press the ▼ volume down button
BP210 only *
Increase sidetone level (5 steps)
Press IC1 while you repeatedly press the ▲ volume up button
BP210 only *
Decrease sidetone level (5 steps)
Press IC1 while you repeatedly press the ▼ volume down button
* NOTE: There is no sidetone adjustment function for All-In-One Headsets.
NOTE: If you are not connecting a wired intercom, go on to System Operation, section 3, page 14.
Power button

Clear-Com HME DX210 Specifications

General

Brand	Clear-Com
Model	HME DX210
Category	Intercom System
Language	English