3
When installing this Car Seat with the Base:
√ Car Seat is securely installed in a vehicle rear seat.
– If car seat must be installed in a front seat, the front air bag for that position
MUST be deactivated and the vehicle owner’s manual MUST state that this is an
acceptable position to install a rear-facing car seat.
√ Base is securely attached to the vehicle using the LATCH Connectors or a vehicle
belt.
√ Base is installed with the Load Leg, and Load Leg is adjusted so the Load Leg
Pressure Indicator is green.
– If not able to use Load Leg, it is recommended to install with vehicle belt.
ALWAYS store the Load Leg when not in use.
√ Base is adjusted to the correct recline adjustment position for the child’s weight.
√ Carrier is securely attached to the Base, and Release Handle on the front of the
Base is in closed position with no red visible.
√ Harness is buckled and snugly adjusted on the child.
√ Carry Handle is adjusted to and locked in the upright position.
To Next Page
Loading...
