Clek Liing - Installing Car Seat without Base with Vehicle Belt

79
Step 1
Secure child in Carrier. See “Securing Your Child in Car
Seat” on page 29.
Step 2
Select a forward-facing vehicle seating location which
has a vehicle belt which can be used with this car seat.
Step 3
If the vehicle seat back is adjustable, make sure the seat
back is locked in a more upright position. Refer to vehicle
owner’s manual for recommended seat back angle. DO
NOT install or use this car seat while the vehicle seat
back is excessively reclined, as shown in Figure 74.
Step 4
Move the front seat of the vehicle all the way forward.
This will give you more room to install the Carrier.
Step 5
Adjust or confirm that the Carry Handle is locked in
upright position. To adjust Carry Handle: press both
Carry Handle Adjustment Buttons and rotate Handle until
it locks in the upright position as shown in Figure 75.
Figure 74
Figure 75
Installing Car Seat without Base with Vehicle Belt