Clek Liing - Installing Car Seat Base with LATCH

53
Step 1
Select a forward-facing vehicle seating location which
has LATCH, as shown in Figure 39. Locate the vehicle
LATCH lower anchors as explained in “Vehicle Child
Restraint Anchorage System (LATCH)” on page 41 in this
manual and in your vehicle owner’s manual.
WARNING
• Only use the Car Seat Base LATCH system in vehicle seating
locations designated by the vehicle manufacturer for use with LATCH
and that have a standard anchor spacing of 11 in. (280 mm).
• If your vehicle has a storage compartment under the floor, install
Base with Load Leg in that seating position only if approved by the
vehicle manufacturer.
• ALWAYS store the Load Leg when not in use.
Installing Car Seat Base with LATCH
Figure 39