54
Figure 41
Step 2
Move the front seat of the vehicle all the way forward.
This will give you more room to install the Base.
Step 3
If the vehicle seat back is adjustable, make sure the seat
back is locked into an upright position. Refer to vehicle
owner’s manual for recommended seat back angle. DO
NOT install or use this car seat while the vehicle seat
back is excessively reclined, as shown in Figure 40.
Step 4
Rotate the Load Leg out into the use position by pulling
the Load Leg out from the Load Leg Storage on the
bottom of the Base, as shown in Figure 41.
IMPORTANT: Clek STRONGLY RECOMMENDS using
the Load Leg. However, if you cannot use the Load Leg,
Clek recommends installing the Base with a vehicle belt,
and not with LATCH. To install the Base with a vehicle
belt, go to “Installing Car Seat Base with Vehicle Belt”
section on page 64.
If you cannot use the Load Leg and are installing the
Base with LATCH, leave the Load Leg in the Load Leg
Storage position and go to the next step.
Figure 40
To Next Page
Loading...
