CLIVET TALK - Setting the Software Address

Data creazione 10/09/03 DS03I009GB--00 Pagina 19 di 59
SETTING THE SOFTWARE ADDRESS
To correctly configure the modules in a local network, set the parameters as shown below
UNIT 1
Add Code
Description Default
39 U1_Mcomp1 Type of compressors, module 1 unit 1 2
40 U1_RecoverEn1 Enable recovery, compressor module 1 unit 1 0
41 U1_Mcomp2 Type of compressors, module 2 unit 1 2
42 U1_RecoverEn2 Enable recovery, compressor module 2 unit 1 0
43 U1_Mcomp3 Type of compressors, module 3 unit 1 0
44 U1_RecoverEn3 Enable recovery, compressor module 3 unit 1 0
45 U1_MEvap Enable evaporator module, unit 1 0
69 U1_Weightprobe Weight on average Out, unit 1 100
46 U1_VentilType Type of ventilation, unit 1 1
UNIT 2
Add Code
Description Default
47 U2_Mcomp1 Type of compressors, module 1 unit 2 0
48 U2_RecoverEn1 Enable recovery, compressor module 1 unit 2 0
49 U2_Mcomp2 Type of compressors, module 2 unit 2 0
50 U2_RecoverEn2 Enable recovery, compressor module 2 unit 2 0
51 U2_Mcomp3 Type of compressors, module 3 unit 2 0
52 U2_RecoverEn3 Enable recovery, compressor module 3 unit 2 0
53 U2_MEvap Enable evaporator module, unit 2 0
70 U2_Weightprobe Weight on average Out, unit 2 0
54 U2_VentilType Type of ventilation, unit 2 0
UNIT 3
Add Code
Description Default
55 U3_Mcomp1 Type of compressors, module 1 unit 3 0
56 U3_RecoverEn1 Enable recovery, compressor module 1 unit 3 0
57 U3_Mcomp2 Type of compressors, module 2 unit 3 0
58 U3_RecoverEn2 Enable recovery, compressor module 2 unit 3 0
59 U3_Mcomp3 Type of compressors, module 3 unit 3 0
60 U3_RecoverEn3 Enable recovery, compressor module 3 unit 3 0
61 U3_MEvap Enable evaporator module, unit 3 0
71 U3_Weightprobe Weight on average Out, unit 3 0
62 U3_VentilType Type of ventilation, unit 3 0
At this point, the local network is configured correctly to receive the setting of the unit operating
parameters.