Cloos GLC 503 MC3 - Page 48

B-30
Programming
GLC 353/503/553 MC3
- The next value to be entered is the
End crater parameter. Press the key
Operating mode and set the required
capacity.
Start welding to determine the required
value.
Use the key Up or
Down until the required arc
has been set. The potentiometers
on the wire drive unit operation
panel can be used for precise
setting.
- Press and release the key Operating mode. Enter
the percentage for Wire burn back.
Use the key Up or
Down until the required value
has been set.
- The last value to be programmed is the
Gas postflow. Press and release the key
Operating mode.
Use the key Up or
Down until the required value
has been set.
4
2
4
2
4
2
P4 Programmieren eines Schweißprozessablaufs