Clorius Controls ER 2022S - Page 54

Compact controller ER 2022S and ER 2022SA
www.clori uscontrols.com
54 of 69
8. Configuration
8.9 Interface “intE”
Start of autotuning during operation
Starting
auto- tuning
h Start with
I
and
D
(simultaneously >2sec
“tUnE” is shown, blinking, in the lower display
Autotuning is ended when the display automatically
changes over to normal display.
The duration of autotuning depends on the control
process.
The controller output types must be defined for autotuning.
v
Chapter 8.2 “Controller “Cntr””
For a program controller, autotuning can only be started in the normal display.
Canceling
auto - tuning
h Cancel with I and D (simultaneously)
H