CMC S19HD - Page 97

MAN.234 Rev.6 ENG - Use and maintenance manual S19HD page 95 of 126
A biodegradable hydraulic oil, called BIOHYDRAN
TMP 46, can be supplied as *optional:
Density, 15°C, kg/l
ASTM D4052
0,920
Kinematic Viscosity, 40°C,
mm2/s
ASTM D445
46
Kinematic Viscosity,
100°C, mm2/s
ASTM D445
9,3
Viscosity Index
ASTM D2270
185
Pour point °C
ASTM D97
-42
Flash point COC, °C
ASTM D92
300
In case of refilling or replacement, it is
imperative to use the same hydraulic oil
(or equivalent) and respect the technical
specifications of the product already pre-
sent in the hydraulic circuit.
Motor oil:
Texaco Motor Oil S 5W-40
Density, 15°C, kg/l
ASTM D4052
0,850
Kinematic Viscosity, 40°C,
mm2/s
ASTM D445
76
Kinematic Viscosity,
100°C, mm2/s
ASTM D445
12,9
Viscosity Index
ASTM D2270
171
Pour point °C
ASTM D97
-43
Flash point COC, °C
ASTM D92
232
Grease:
• for boom extension and outriggers:
Interflon Fin Grease LS1/2
Composition: mixture of mineral oils, calci-
um-lithium complex thickener, additives and
Teflon®. (working range: from -20°C to
+120°C)
• for fifth wheel, greasers, bearings, pins and
supports:
ARTOS-BA NF 2
Composition: mixture of mineral oils and ad-
ditives. NLGI 2 class.
(working range: from -20°C to +160°C)
Lubricant:
• for chains:
Interflon Fin Lube Ep Plus
Composition: mixture of mineral oils and
vegetables, additives and Teflon®.
Density at 20°C: 0,89 g/cm3
Kinematic Viscosity at 20°C (ASTM D2983):
380 mPa.