MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 19 of 138
Before starting the engine, especially if the MEWP is
used in workplaces with low atmospheric temperatures,
it is advisable to heat the spark plugs of the machine
motor while keeping the key on the symbol for a few
seconds: this will cause the corresponding orange light
2 (Picture 4) to turn on.
Picture 5: heating phase of the engine spark plugs.
The ignition of the endothermic engine can also be
carried out with the help of the radio control or of the
console in the basket.
Using the radio control:
• turn the key to position 1;
• connect the radio control (link procedure in par.
3.2.2),
• move the lever in the Picture upwards, present on
the left side of the radio control under the joystick
J1 (Picture 7);
• in this case, the green light 5 (Picture 4) will light up
both on the key station and on the radio control, to
signal the correct power supply of the machine.
Otherwise, using the console in the basket (already wired
to the machine):
• turn the key to position 1;
• press the endothermic engine start button 9
(Picture 11)
• also, in this case, the green light 5 (Picture 4) will
light up both at the key station and on the console,
to signal the correct power supply of the machine.
Picture 6: power on/off lever on the radio control.
To Next Page
Loading...
Need help?
General
