MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 21 of 138
• re-press the on/off button 10 on the console in the
basket;
• press, in emergency situations, one of the
emergency buttons provided on the machine (par.
4.6.1).
3.1.3 Other power supplies *optional
The machine can be supplied on request completely with
a 48 V electric motor powered by 200 Ah lithium batteries
or with a hybrid feed.
It is not possible to have the 48 V electric
motor and the 110/120/230 V one activated on
the machine at the same time.
It is not possible to turn on both the
endothermic engine and the electric motor at
the same time.
The start and stop of the 48 V electric motor will be the
same shown above for 110/120/230 V electric motor.
To recharge the batteries:
1. couple the socket (power line) to the plug on the
machine and lift the button provided on the
machine's thermal magnetic panel;
2. the batteries will be charging and, if the electric
system is ON, the progress of the charging process
will be shown on both the control station display
and the appropriate leds of the box in the basket.
When the state of batteries charge, during
the use, reaches the lowest level (under 10%),
all work maneuvers will be interrupted, and it
will only be possible to close the machine
again.
It is absolutely forbidden to direct high-
pressure jets of water onto the support
containing the battery pack. High water
pressure could generate serious and
irreversible problems in the operation of the
machine.
To Next Page
Loading...
Need help?
General
