2201R Mobile Tester User Guide
Chapter 3 Performing manual tests and measurements in GSM mode
47090/322
Copyright © 2015 Aeroflex Limited. All rights reserved.
77
6. Switch on the mobile phone, and wait until it indicates that it has found a base station.
7. If the mobile phone does not perform a GPRS Attach automatically, enable the GPRS mode in the phone so that
it registers with the GPRS routing area.
The status field displays GPRS Attached, and the GPRS Start Test and Tx Test soft keys are accessible.
8. In the Mode selection field, select BLER BCS.
9. You may want to select a different number of samples in the range from 1 to 10,000 blocks; the default is 100.
Note
Ensure that you keep this sequence of steps, there may be restrictions in the test capabilities
otherwise.
To Next Page
Loading...
Need help?
General