OpenAMIP setup for iDirect iNFINITI & Evolution
98-145510-E Appendix C: VSAT modem settings C-4
Protocol
The ACU supports all OpenAMIP commands except the X command which is optional. All
the supported OpenAMIP commands are shown in the following figure.
Figure 4: Supported OpenAMIP commands
Messages sent from VSAT
modem
Explanation
S -15.000000 0.000000
0.000000
Longitude, Max_lat, Pol_skew
H 1451.815000 1.905000 Hunt_frequency, Hunt_bandwidth
P H V Rx_polarity, Tx_polarity
B 11250.000000
12800.00000
Rx-lcl_osc, Tx_lcl_osc
T 1403.290000 0.618000 Tx_frequency, Tx_bandwidth
A 15 Keepalive_interval in mS [ACU: s message]
W 300 latlong_interval in seconds [ACU: w message]
L 1 1 Rx lock, Tx allowed
K 90.000000 Max_skew
Table C-5: Messages sent from the VSAT modem to the ACU (examples)
To Next Page
Loading...
