Lists of events
98-145510-E Appendix E: System messages E-3
0806D-0 ERROR Antenna power The antenna supply voltage is outside the allowed limits.
This may happen if the PSM fails to provide the
requested supply voltage.
0806E-0 ERROR VMU reference signal There is no VMU Rx or Tx reference signal. Whether this
is Rx or Tx reference depends on the user's selection on
the modem profile page in the web interface. Make sure
the VMU Rx/Tx cable is connected and that the VMU is
configured to output the RX/TX reference signal.
0806F-0 WARNING ROSS synchronization The ACU has become out of sync with the ROSS device,
most likely because the ACU has been replaced, or the
ROSS satellite profile is new. A manual (forced) handoff
sequence must be initiated from the ROSS, refer to the
ROSS manual.
08073-0 WARNING Slave connection The system is configured as a dual antenna master, but
no dual antenna slave is connected to it. Either disable
the dual antenna master in the web interface or
configure a another system as a dual antenna slave.
08074-0 WARNING Master connection The system is configured as a dual antenna slave, but it
was not possible to connect to the dual antenna master.
Check that the IP address entered in the modem profile
is correct and check that the master and slave systems
are physically connected as described in the manual.
08075-0 WARNING Rx cable calibration The calibration of the ACU-antenna cable failed. The
cable could be defective, too long, of too poor quality,
not properly connected, or the VIM or ACU hardware
could be defective.
08076-0 WARNING Incompatible
message version
The system is configured as a dual antenna system, but
the software versions on master and slave system are
different. Ensure that both master and slave have
identical software.
08078-0 WARNING VMU TX frequency
invalid
The satellite modem did not provide a Tx frequency, or
it is invalid. A default Tx frequency is assumed, but this
may degrade Tx performance. To remove this warning
re-configure the modem to provide the correct Tx
frequency.
08079-0 WARNING ACU Fan Internal fan is malfunctioning.
Error
code (ID)
Severity Description Explanation
Table E-1: Event messages for ACU (Continued)
To Next Page
Loading...
