COBHAM EXPLORER 8100 - Page 166

Lists of events
98-145510-E Appendix E: System messages E-4
0807A-0 WARNING Automatic azimuth
calibration pending
Automatic azimuth calibration mode is enabled. The
system tries to perform an azimuth calibration using the
target satellite whenever satellite data is received from
the modem. After successful calibration the feature is
automatically disabled and the system returns to normal
operation. WARNING: If a system has not completed
azimuth calibration after the installation, the blocking
zones may appear to be at wrong angles.
0807C-0 ERROR System configuration Invalid ACU / antenna combination.
0807D-0 WARNING TRIA communication The SurfBeam modem cannot communicate with the
TRIA. Try power cycling the modem.
08100-0 ERROR PSM low voltage (22
V)
The ADM measures a different antenna voltage than
expected. If the problem is not solved by a restart, and
the PSM is not reporting any errors, the ADM is probably
defective.
08101-0 ERROR PSM high voltage (48
V)
The ADM measures a different antenna voltage than
expected. Check for short circuit of the antenna coax
connector. If the problem is not solved by a restart, and
the PSM is not reporting any errors, the ADM is probably
defective.
08102-0 ERROR PSM 5 V power Internal voltage supply error of the ADM.
08103-0 ERROR ADM hotswap The ACU is not able to supply the correct voltage to the
antenna. Check for short circuits in coax cable and the
antenna
08104-0 ERROR Antenna
communication
The ACU cannot communicate with the antenna. Check
cable and antenna.
08107-0 ERROR ADM FPGA load The ADM FPGA cannot be initialised and loaded.
08108-0 ERROR TX Power Detector
calibration
The power detector calibration is not valid.
08109-0 ERROR Antenna XIM data There is a mismatch in the antenna configuration data.
Either the PCM or the VIM in the antenna are
malfunctioning or one of them has been replaced. In the
latter case, select which is the original device in the web
interface and restart the system.
0810A-0 ERROR ADM production data Production data has been corrupted.
Error
code (ID)
Severity Description Explanation
Table E-1: Event messages for ACU (Continued)