Lists of events
98-145510-E Appendix E: System messages E-10
0A058-0 WARNING PMM warning The polarisation motor controller has temporarily
observed an unusual situation with regards to
temperature, voltage, current or velocity. No user
interaction required.
0A059-0 WARNING Azi cal. limits Check limits of the calibration result for the azimuth axis
are exceeded. Pointing performance may be degraded.
Info: 0x00000040: End stop detected before expected
limit 0x00000100: Zero width is low
0x00000200: Zero width is high 0x00000400: Zero
slack is high 0x00001000: Friction average is high
0x00002000: Friction peak is high 0x00004000:
Friction asymmetry is high Zero width low/high: Zero
reference module placement may be incorrect. Zero
slack high: Mechanical slack may be too high. Friction
average/peak high: Mechanical friction is higher than
expected. Friction asymmetry high: Mechanical
imbalance may be too high.
0A05A-0 WARNING Xel cal. limits Check limits of the calibration result for the cross-
elevation axis are exceeded. Pointing performance may
be degraded. Info: See 0A059-0.
0A05B-0 WARNING Ele cal. limits Check limits of the calibration result for the elevation
axis are exceeded. Pointing performance may be
degraded. Info: See 0A059-0.
0A05C-0 WARNING Pol cal. limits Check limits of the calibration result for the polarisation
axis are exceeded. Pointing performance may be
degraded. Info: See 0A059-0.
0A05D-0 WARNING ISM warning The ISM has temporarily observed an unusual situation
for temperature or voltage. No user interaction required.
If repeated after cooldown and reboot, check if the ISM
or cables around it are defective.
0A05E-0 WARNING Low elevation The antenna is not allowed to transmit because the
elevation is too low.
0A05F-0 WARNING Heading range Heading data range error. External heading unit supplies
unreliable data.
0A062-0 WARNING High elevation The antenna cannot perform acquisition in gyro-free
mode because the elevation is too high.
0A065-0 ERROR Deploy/Stow Deploy/stow error. The antenna did not properly unlock
(deploy), or the stow switch never closed (stow).
0A066-0 ERROR OMT error Problem with OMT. Temperature out of range or OMT
cable may be broken.
Event ID Severity Description Explanation
Table E-2: Event messages for antenna (Continued)
To Next Page
Loading...
