The web interface
98-145510-E Chapter 6: Setup and operation 6-15
Static IP or DHCP Client
If you select DHCP client the network IP address and sub-net mask must be provided by a
DHCP server on that network. If you select Static you must specify a unique IP address and
a sub-net mask.
DHCP Server Settings
When Mode is set to Static, you can select to let the LAN port act as a DHCP server.
The DHCP start and end addresses must be on the same subnet as the port's static IP.
DNS setup
If you have access to a Domain Name Server (DNS) you can specify the address of the
email server by using the server name instead of its IP address. This can be used in Outgoing
mail server in Email setup on page 6-17.
Make sure that the networks do not use IP address ranges that overlap.
Sections Preferred use
NETWORK
Host
name
The host name is used for identifying the VSAT system, and is displayed in
the web interface (right side of top line, next to the product name). The
default host name is acu. You can change the name. Letters (a-z), digits (0-9)
and hyphen (-) are allowed as legal characters.
Note: The host name must start with a letter.
LAN Port 1 LAN port 1 is the service port and is used to access the web interface. By
default this port has the static IP address http://192.168.0.1; the current
value can be shown in the ACU display (NETWORK > PORT 1 IP).
If you want a different setup for LAN port 1, you can change the IP settings.
You get the default settings back by resetting to factory default.
LAN Port 2, 3
and 5
By default, LAN port 5 is dedicated to the modem connection. If you want a
different setup for LAN port 5, you can change the IP settings.
LAN 3 and 5 are switched with LAN 2, i.e. they are always on the same
network and have the same IP settings as LAN 5.
LAN Port 4 LAN port 4 is configured to be a DHCP client. You can change the IP settings
according to your needs.
WLAN The wireless port can be connected to one of the other ports.
Set here which of the ports 1 to 5 you want to access with WLAN. If you
want to access the web interface with WLAN, select the service port (LAN 1
by default).
For details on the WLAN interface setup, see WLAN settings on page 6-16.
Table 6-11: Setup of LAN network
The DHCP server is enabled by default.
To Next Page
Loading...
