The web interface
98-145510-E Chapter 6: Setup and operation 6-23
position coordinates of the active profile, but you cannot change the coordinates of
the active profile.
• If you selected Jog, the antenna will not be transmitting, and you can enter any
position coordinates.
5. Click the arrow buttons for Azimuth or Elevation to change the offset, or type in specific
values.
and change the offset with 0.1° increments.
and change the offset with 1.0° increments.
The current position as well as the offset is shown on the screen.
6. For Ka-Band: Select Deactivate to return to normal operation and reactivate the
selected satellite profile.
7. For Ku-Band only: Continue to the next steps.
8. Click the arrow buttons for TX polarisation to change the offset, or type in a specific
value. You may also select Add 90°.
The current position as well as the offset is shown on the screen.
9. Click Save polarisation offset.
10.Enter the correct Modem CW frequency.
This is provided by the satellite operator, typically when talking to the satellite operator
on the phone before doing a P1dB compression measurement.
11.When the lineup or jog procedure is ended, select Deactivate to return to normal
operation and reactivate the selected satellite profile.
For information on the submenus Modem and Antenna data, see chapter 7, Service and
maintenance.
Figure 15: To line up or jog the antenna using the web interface
There may be slight deviations (or “random walk”) of a few tenths degrees.
To Next Page
Loading...
