Maintenance
HF SSB Transceiver 9323/9360/9390/9780 Technical Service Manual 5-17
Message Description
BBRAM Ck/Sum Err Data corrupted in Battery Backup RAM
IC112 [1 04-02976 Sheet 1].
BBRAM Update Failed Cannot write data to Battery Backup RAM
IC112 [1 04-02976 Sheet 1].
Disconnect Err Transceiver received a "disconnect call" when
not operating with an IPC–500.
External RAM Bad On power up, unable to write to Parallel
RAM IC104 [1 04-02976 Sheet 1].
FSK calibration fail The selcall decoder is not calibrated.
I2C Bus Error
XXXX:XXXX
Major hardware fault on one of the internal
I
2
C bus lines.
Intrnl Tmr Alloc Err The transceiver detected an internal timer
allocation error.
Loading ALE data This should be displayed on power up for a
short period when the ALE Controller is
connected.
Low Battery Battery supply is below 10 V.
No Channels Fitted Cannot find any programmed channels. If
programmed channels exist but cannot be
located, the Parallel E
2
PROM IC105 is
corrupted [1 04-02976 Sheet 1].
No deflt rec for XX The transceiver could not read a default
record.
Parallel EEPROM Bad Unreliable data from IC105 [1 04-02976
Sheet 1].
RAM Fault Cannot read data from Parallel RAM IC104
[1 04-02976 Sheet 1].
RTC Ck/Sum Err The transceiver detected a real time clock
checksum error.
SEEPROM Ck/Sum Err Data corrupted in Serial E
2
PROM IC108 [1
04-02976 Sheet 1].
Serial BBRAM Bad On power up cannot write reliably to Battery
Backup RAM IC112 [1 04-02976 Sheet 1].
Serial EEPROM Bad On power up cannot write reliably to Serial
E
2
PROM IC108 [1 04-02976 Sheet 1].
Serial EEPROM Fail XX Detected error in writing data to Serial
E
2
PROM IC108 [1 04-02976 Sheet 1].
Unknown error: XX The transceiver detected an unknown data
error.
Unlock Error VCO1 VCO1 unlocked.
To Next Page
Loading...
Need help?
General
