Code Blue IP2501-s - Page 44

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-137-Hpage 44 of 67
IP1500 and IP2500 Series
Administrator Guide
ConguringDiagnostics
Diagnostic Settings
Thespeakerphonediagnosticsettingsareconguredby:
• Selecting Diagnostic Settings in the Code Blue Conguration.
• Click the Enablecheckbox.
• InputtheSNMP Server IP address
and SNMP Server Port number to
monitorthespeakerphonewithan
SNMP management software or with
CodeBlue’sToolVoxGateway,with
UnitProgramming&Diagnostic(UPD)Software.
• PoEPowerFailure:PoEpoweristhesolepowersourceandifaninterruptioninserviceisexpe-
rienced,noTrapwillbesentduetolossofPoEenergy.ThePoEswitchshouldalertyoutoPoE
switch state.
Others – (Tests)
Microphonetestingisdisabledbydefault,andenablingwillshowanumberofreoccurringtest
routines.Themicrophoneissupportedbythespeaker’sabilitytogeneratetonesattheschedule
intervals.
• Thetestconsistsofbeepsfromthespeaker,whichwillbereceivedbythemicrophone.
The maximum number of beeps: 10 beeps
 Oncethemicrophonedetectsthebeeps,thetestiscompleteuntilthenextscheduledtestis
 present.
The beep tone volume choices are soft, loud, or soft to loud.
 Beeptonevolumesettingshouldbesettoanticipateambientnoiselevelatthetimeofthe
test.
• The test schedule choices are:
 Every15minutes
 Hourly
Daily
Weekly
Testingondemand:Whenmicrophonespeakertestingisenabled,theadministratormayselectto
Run Test whileloggedintothespeakerphone.Theresultsofthetestwillonlybepresentinafailed
SNMPtrap,whichwouldappearintheSNMPserverlogsorUPDDiagnosticReportslogs.TheMIB
valueisCODEBLUE-MIB::micSpeakerFailure.