100
Time, in 1/100 seconds, after the pressure sensor should have
reported the coffee brew chamber depressurised but has not, that a
flag is set to perform an extra rotation of the brewer at the end of the
next brewer drink cycle
1
Do not display information about
the state of the filter belt on the
user display
0
Display belt warnings on the user
display
0
Do not automatically exit
engineer’s mode
30 (recommended)
Time in 1/10 seconds after
which, if no key is pressed exit
from the engineer’s program will
commence
2
Number of retries at dispensing a cup before a long delay until next
cup occurs to deter theft
0 Don’t display currency symbol
1 Currency symbol is £
2 Currency symbols is €
3 Currency symbols is $
0
Time, in 1/100 seconds, after the machine display has been inactive
till it will revert to a screen saving mode
1
The number of times the machine will allow the water tank to reset to
fill again, this number can be altered to allow more resets
0
Fully encode products, i.e., send
product code for: Cheap Own
cup, Cheap No cup, Normal Own
cup and Normal No cup
1
Go light on product codes. MDB
sends just one number per
selection regardless of price.
N&W card reader fix
170 Size of drink in cc.
Assuming machine default parameters and valves were set up to
give 170cc then this variable can be used to scale all drinks together
to rapidly accommodate changing cup sizes
0 Grinds after vend so Doser is full for next vend
8 The setting the Doser is on
0 Extra strength options on group drinks
0 Compensation for low flow rate if grind is fine.
1 Extra temperature to pre-heat group boiler
0 Alternate rest position for group brewer
To Next Page
Loading...
Need help?
General