EasyManua.ls Logo

Cold Jet i3 MICROCLEAN 2 - Status Screen

Cold Jet i3 MICROCLEAN 2
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41 2023-08-29
Click to go to Top of Document
Problem
Possible Reason
Solution
Machine will not blast
Air supply not connected / air supply not
on.
Check the air supply hose
connections and make sure the
air supply is on.
Applicator control cable not connected to
the machine or the applicator
Check control cable connections
between the machine and the
applicator
Machine blasts air but
not pellets
The switch on the applicator is set to Air-
Only (I) mode.
Set the applicator to Air+Dry Ice
(II) mode
The dry ice trough is clogged.
Contact Cold Jet for support
Warranty Policy
Cold Jet, LLC® (“CJ”) warrants its products (“Equipment”) provided under this Agreement to be free from
defects in materials and workmanship for a period of 12 months (90 days for used equipment), under
normal use, maintenance and service as stipulated in the Operator’s Manual, Commissioning, and
Operator Training. At the discretion of CJ, failure to complete Installation, Commissioning, and Operator
Training shall result in forfeit of warranty rights. CJ warrants that the equipment will be in good working
order on the Date of Shipment and will conform to CJ’s official published specifications.
The warranty period is 12 months (90 days for used equipment) for CJ manufactured Equipment. Original
Equipment Manufacturers’ warranties provided by CJ on equipment purchased under this Agreement
not manufactured by CJ will be passed through to the Buyer. The warranty period commences on the
Date of Shipment of the Equipment.
CJ’s liability is limited to repairing or replacing, at its option, any covered part of its Equipment which CJ
has determined to be defective. Said repair or replacement will be made by CJ or its authorized
representative free of charge to the Buyer during the warranty period. Any replaced part will become
the property of CJ. If, after repeated efforts, CJ is unable to restore its Equipment to good working order,
or to replace the defective parts, all as warranted, CJ may replace the Equipment in its entirety at its
discretion. Any claim must be made in writing to CJ within 30 days after the defect is discovered and any
claim not made within that period shall be deemed waived or released and denied.
Warranty service provided under this Agreement does not assume uninterrupted operation of the
Equipment. The suitability of the equipment for the purpose intended is not included in the warranty.
This warranty shall not apply and CJ shall not be responsible nor liable for:
a) Consequential, collateral or special losses or damages;
b) Equipment conditions caused by abnormal conditions of use, accident, neglect or misuse of
equipment, improper storage or damages resulting during shipment as determined by CJ;

Other manuals for Cold Jet i3 MICROCLEAN 2

Related product manuals