16. MAINTENANCE
Taillight /Brakelight Lamp Replacement
If the taillight / brakelight does not work the lamp may need to be
replaced.
1. Remove the lens.
2. Remove lamp and replace it with
recommended lamp.
3. Test the taillight/ brakelight to see
that it’s working .
4. Reinstall the lens.
Indicator Lamp Replacement
1. Remove mounting panel.
2. Unplug light from harness, depress locking tabs (A) and
remove from pod.
3. Install new light and reassemble panel.
High Beam Headlight Adjustment
The headlight beam can be adjusted up and down.
1. Place the vehicle on a
level surface with the headlight
approximately 25’(7.6m) from a wall.
2. Measure the distance from the
floor to the center of the headlight
and make a mark on the wall at the
same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight
beam should be aimed 2’ (51mm) below the mark placed on
the wall in step 2. NOTE : Riding weight must be included on
the seat.
5. Turn screw(1) and screw(2) to adjust the beam to the desired
position.(FOR 05)
Loosen pivot bolt and adjust beam to desired position.(FOR 04)
6. Tighten nut and bolt.(FOR 04)
97
To Next Page
Loading...
