Cooling System
WARNING
Never remove the pressure cap when the engine is warm or hot.
Escaping steam can cause severe burns. The engine must be
cool before removing the pressure cap.
Radiator Coolant Level Inspection
NOTE: This procedure is only
required if the cooling system
has been drained for maintenance
and/or repair. However, if the
recovery bottle has run dry, the
level in the radiator should be
inspected and coolant added if necessary.
NOTE: Use of a non-standard pressure cap will not allow the
recovery system to function properly. If the cap should need
replacement contact your dealer for the correct replacement part.
To insure that the coolant maintains its ability to protect the
every two years and a fresh mixture of antifreeze and water be
added.
Using a funnel, slowly add coolant as necessary through the
radiator filler neck.
40
engine, it is recommended that the system be completely drained
To Next Page
Loading...
