16. MAINTENANCE
Transmission Oil Changing Procedure
1. Remove the four screws on the footwall and gently pull
outward for access.
2. Remove fill plug.
3. Remove transmission drain plug located on the bottom left
hand side and drain the oil. Catch and discard used oil
properly.
4. Clean and reinstall the drain plug torque to 14 ft.lbs. (20Nm）
5. Add the correct amount of SAE 80W/90GL5 Lubricant until oil
reaches the bottom of the filler hole
6. Check for leaks.
7. Reinstall footwall and screws removed in step 1.
91
To Next Page
Loading...
