16. MAINTENANCE
Rear Gearcase Lubrication
Which the ATV on the a level surface, remove fill plug and visually
inspect the lubricant level through
the fill hole(1).Lubricant should be
kept even with the center of the drill
point (2) approximately 1 5/8”
(41mm) below the top of the fill hole.
NOTE: Do not add lubricant to the
bottom of the fill plug threads. The correct gearcase lubricant to
use is SEA 80W/90 GL5 Weight Gear Lube.
Oil Changing Procedure
1. Remove drain plug (3). Catch and
discard used oil properly.
2. Clean and reinstall the drain plug
with a new sealing washer and
tighten securely (14 ft. lbs/20N.m).
3. Remove fill plug and add 10 ounces
(300ml) of SEA 80W/90 GL5 Weight
Gear Lubricant and oil level. Oil level should be kept even with
the center of the drill point (approximately 1 5/8”41mm below the
top of the fill hole).
4. Reinstall the fill plug. Tight securely (14 ft. lbs/20N.m).
5. Check for leaks.
92
To Next Page
Loading...
