Colorlight X16 User Manual

www.colorlightinside.com
7
4.2.1 Mapping Settings
Select the target Ethernet port on the left side, and then select the corresponding
cabinets within the actual control area of the port and set the connection lines in the
simulated cabinet area.
In the simulated cabinet area, select the corresponding cabinet of the first receiving
card based on the actual connection of the Ethernet port (view from the front), and left-click
the cabinet one by one according to actual connecting line, until the last one this Ethernet
port controls.
For the cabinets with different specifications (different in dimensions), you can select
them and adjust the mapping separately after setting.
4.2.2 Saving Mapping
After successively setting the cabinets each port controls and their mapping, click
Send and Save to Devices at the bottom of the window to send and save the mapping to
the current sender and receiving cards.

Colorlight X16 Specifications

General

Brand	Colorlight
Model	X16
Category	Controller
Language	English