ComAp IG-NT - Page 276

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
276
The counter value can be reset in the InteliMonitor statistics window.
NOTE:
Available in IS-NT only.
Binary input: Timer block 1
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #1.
NOTE:
See also the setpoint TimerChannel 1 and output TimerAct 1-4.
NOTE:
See the chapter Timers for more details about timers.
Binary input: Timer block 2
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #2.
NOTE:
See also the setpoint TimerChannel 2 and output TimerAct 1-4.
NOTE:
See the chapter Timers for more details about timers.
Binary input: Timer block 3
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #3.
NOTE:
See also the setpoint TimerChannel 3 and output TimerAct 1-4.
NOTE:
See the chapter Timers for more details about timers.
Binary input: Timer block 4
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #4.
NOTE:
See also the setpoint TimerChannel 4 and output TimerAct 1-4.
NOTE:
See the chapter Timers for more details about timers.
Binary input: Timer block 5
Related FW
3.0