IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
This setpoint adjusts the reset (initial) value of the ExtValue 2. This initial value is
applied either when the controller is powered-on or when the ExtValue 2 is reset
by the binary input ExtValue2reset.
-32000 .. ExtValue2HiLim [X]
This setpoint adjusts the low limit of the value of ExtValue 2 if the value is
lowered/raised by the binary inputs ExtValue2 up and ExtValue2 down. The
ExtValue 2 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 2 is written remotely from
a terminal using the appropriate command ExtValue #n.
NOTE:
For IS-NT only.
ExtValue2LoLim .. 32000 [X]
This setpoint adjusts the high limit of the value of ExtValue 2 if the value is
lowered/raised by the binary inputs ExtValue2 up and ExtValue2 down. The
ExtValue 2 is never raised over this limit.
NOTE:
This limit is not taken into account if the value ExtValue 2 is written remotely from
a terminal using the appropriate command ExtValue #n.
NOTE:
For IS-NT only.
To Next Page
Loading...
Need help?
General
