ComAp IG-NTC GC - Page 200

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
200
See also the setpoint TimerChannel 16 and output TimerAct 13-16.
NOTE:
See the chapter Timers for more details about timers.
Binary input: ExtValue1 up
Related FW
3.0
Description
For IS-NT only.
While this input is active the value of ExtValue 1 is contiously beeing increased at
the rate of ExtValue1 rate until it reaches ExtValue1HiLim.
NOTE:
If this input is used (configured), the ExtValue 1 can't be written remotely from a
remote terminal using the command ExtValue 1.
Binary input: ExtValue1 down
Related FW
3.0
Description
IS-NT specific function
While this input is active the value of ExtValue 1 is contiously beeing decreased at
the rate of ExtValue1 rate until it reaches ExtValue1LoLim.
NOTE:
If this input is used (configured), the ExtValue 1 can't be written remotely from a
remote terminal using the command ExtValue 1.
Binary input: ExtValue2 up
Related FW
3.0
Description
For IS-NT only.
While this input is active the value of ExtValue 2 is contiously beeing increased at
the rate of ExtValue2 rate until it reaches ExtValue2HiLim.
NOTE:
If this input is used (configured), the ExtValue 2 can't be written remotely from a
remote terminal using the command ExtValue 2.
Binary input: ExtValue2 down
Related FW
3.0
Description
IS-NT specific function
While this input is active the value of ExtValue 2 is contiously beeing decreased at
the rate of ExtValue2 rate until it reaches ExtValue2LoLim.
NOTE: